Lucent Technologies MAX 6000 Network Configuration Manual page 444

Setting Up Virtual Private Networks
Configuring ATMP tunnels
3
4
5
6
Example of configuring a Home Agent in router mode (IPX)
To configure the Home Agent in router mode to reach an IPX network:
1
2
3
11-14
Specify the password used to authenticate the tunnel (Ascend-Home-Agent-Password).
For example:
ATMP options...
ATMP Mode=Home
Type=Router
Password=private
SAP Reply=No
UDP Port=5150
GRE MTU=1472
Force fragmentation=No
Idle limit=0
ATMP SNMP Traps=No
Exit the profile and, at the exit prompt, select the exit and accept option.
Open a Connection profile and configure an IP routing connection to the Foreign Agent.
For example:
Ethernet
Connections
any Connection profile
Station=foreign-agent
Active=Yes
Encaps=MPP
Dial #=555-1213
Route IP=Yes
Encaps options...
Send Auth=CHAP
Recv PW=foreign-pw
Send PW=home-pw
IP options...
LAN Adrs=10.65.212.226/24
Exit the profile and, at the exit prompt, select the exit and accept option.
Open Ethernet > Mod Config > Ether Options and verify that the LAN interface has an IP
address (needed for communication with the Foreign Agent) and can route IPX.
Ethernet
Mod Config
IPX Routing=Yes
Ether options...
IP Adrs=10.1.2.3/24
IPX Frame=802.2
IPX Enet #=00000000
For details, see Chapter 12, "Configuring IPX Routing."
Open the ATMP Options subprofile, set ATMP Mode to Home, and set Type to Router.
ATMP options...
ATMP Mode=Home
Type=Router
Specify the password used to authenticate the tunnel (Ascend-Home-Agent-Password).
MAX 6000/3000 Network Configuration Guide