Enabling The Vrouter Feature On Ipx - Lucent Technologies MAX 6000 Network Configuration Manual

Hide thumbs Also See for MAX 6000:

Table of Contents

The IPX VRouter feature enables logical grouping of the interfaces for secure IPX networks.

Each of the private networks maintains its own

Enabling the VRouter feature on IPX

To enable the VRouter feature on IPX, you must first enable IPX routing on the MAX unit by

setting the Ethernet > Mod Config > IPX Routing parameter to Yes. You do not have to set a

separate IPX VRouter parameter, because this feature is just an extension of the existing IP

VRouter feature. You can configure the Ethernet > Virtual Routers profile on the MAX unit to

set up a VRouter.

Note: You can configure up to three Virtual Router profiles on a MAX unit.

RADIUS profiles

The RADIUS attribute Ascend-VRouter-Name specifies the VRouter to which a

Connection profile belongs.

The IPX static route on the RADIUS server specifies the Connection profile to be used to reach

the specified server. Thus, the static route belongs to the VRouter specified in the Connection

MAX 6000/3000 Network Configuration Guide

Packet statistics

IPX routing table

IPX service table

IPX session table

IPX address pools

IPX Ping statistics

IPX traffic statistics

IPX dial-in route tables

Setting Up Virtual Private Networks

Configuring Virtual Routers