Configuring Frame Relay
Concentrating incoming calls onto Frame Relay
Routing parameters in RADIUS
In addition to the attributes described in "Overview of DLCI interface settings" on page 5-13,
the following attribute-value pairs must be specified in the permconn profile of a Frame Relay
gateway:
Attribute
Ascend-Route-IP (228)
Framed-Address (8)
Framed-Netmask (9)
Examples of a gateway configuration
In the following example, the MAX acts as a gateway between a client that dials in with the
address 10.1.2.3/29, and a remote router that is reachable across Frame Relay, as shown in
Figure 5-8:
Figure 5-8. Frame Relay gateway
The following set of parameters configures an MP+ Connection profile for the dial-in client in
Figure 5-8:
Ethernet
Connections
Following is a comparable RADIUS profile:
mpp-client Password="clientpw", User-Service=Dialout-Framed-User
5-20
Preliminary January 4, 2001
Value
Enables/disables IP routing for this connection. (IP is enabled by
default. If this attribute is present, it must be set to Route-IP-Yes
for Frame Relay gateway connections.)
Destination IP address, which lies at the end of a PVC whose first
hop is known by the specified DLCI.
A subnet mask for Framed-Address.
Frame Relay
10.9.8.7/24
mpp-client
Name=mpp-client
Active=Yes
Encaps=MPP
Encaps options
Recv PW=clientpw
IP options
LAN Adrs=10.1.2.3/29
Framed-Protocol=MPP,
Framed-Address=10.10.1.3,
Framed-Netmask=255.255.255.248
DLCI 55
MAX 6000/3000 Network Configuration Guide
10.1.2.3/29