Lucent Technologies MAX 6000 Network Configuration Manual page 548

Parameter
Src Port #
Dst Port Cmp
Dest Port #
Precedence
Type of Service
MAX 6000/3000 Network Configuration Guide
Specifies
A port number to be compared with the source port of a packet.
TCP and UDP port numbers are typically assigned to services. For
more details, see "Filtering by port numbers" on page 15-14.
Type of comparison to perform when comparing destination port
numbers. With a setting of None (the default), no comparison is
made. You can specify that the filter matches the packet if the
packet's destination port number is Less (less than), Eql (equal to),
Gtr (greater than), or Neq (not equal to) the Dest Port # value.
A port number to be compared with the destination port of a
packet. TCP and UDP port numbers are typically assigned to
services. For more details, see "Filtering by port numbers" on
page 15-14.
Priority level of the data stream. The three most significant bits of
the TOS byte are priority bits used to set precedence for priority
queuing. When TOS is enabled and the packet matches the filter,
the bits can be set to one of the following values (most significant
bit first):
• 000—Normal priority
• 001—Priority level 1
• 010—Priority level 2
• 011—Priority level 3
• 100—Priority level 4
• 101—Priority level 5
• 110—Priority level 6
• 111—Priority level 7 (the highest priority)
Type of Service of the data stream. The value of this attribute sets
the four bits following the three most significant bits of TOS byte.
The next four bits of the TOS byte are used to choose a link
according to the type of service. When TOS is enabled and the
packet matches the filter, one of the following values can be set in
the packet:
Normal—Normal service
Cost—Minimize monetary cost
Reliability—Maximize reliability
Throughput—Maximize throughput
Latency—Minimize delay.
Defining Static Filters
Defining Type of Service filters
15-19