Lucent Technologies MAX 6000 Network Configuration Manual page 438

Setting Up Virtual Private Networks
Configuring ATMP tunnels
Table 11-1.Required RADIUS attributes to reach an IP home network (continued)
Home Agent in router mode
Ascend-Home-Agent-UDP-Port
Table 11-2.Required RADIUS attributes to reach an IPX home network
Home Agent in router mode
Ascend-IPX-Peer-Mode
Framed-IPX-Network
Ascend-IPX-Node-Addr
Ascend-Primary-Home-Agent
Ascend-Home-Agent-Password
Ascend-Home-Agent-UDP-Port
Following is a description of each Foreign Agent attribute:
Attribute
Ascend-Primary-Home-Agent
Ascend-Home-Agent-Password
Ascend-Home-Agent-UDP-Port
Ascend-Home-Network-Name
Ascend-IPX-Peer-Mode
11-8
Home Agent in gateway mode
Ascend-Home-Agent-UDP-Port
Ascend-Home-Network-Name
Home Agent in gateway mode
Ascend-IPX-Peer-Mode
Framed-IPX-Network
Ascend-IPX-Node-Addr
Ascend-Primary-Home-Agent
Ascend-Home-Agent-Password
Ascend-Home-Agent-UDP-Port
Ascend-Home-Network-Name
Description
IP address of the Home Agent, used to locate the
Connection profile (or RADIUS profile) for the IP
connection to the Home Agent.
Used to authenticate the ATMP tunnel itself. Must
match the password specified in the Home Agent's
Ethernet > Mod Config > ATMP Options subprofile.
All mobile clients use the same
ATMP-Home-Agent-Password.
Must match the UDP port configuration in Ethernet >
Mod Config > ATMP Options. Required only for a port
number other than the default 5150.
Name of the Home Agent's local Connection profile to
the home network. Required only when the Home
Agent is operating in gateway mode (when it has a
nailed WAN link to the home network). For details, see
"Configuring a Home Agent in gateway mode" on
page 11-15.
Dial-in NetWare clients must specify IPX-Peer-Dialin.
This setting enables the Foreign Agent to handle RIP
and SAP advertisements and assign the mobile client a
virtual IPX network number.
MAX 6000/3000 Network Configuration Guide