Table of Contents
Advertisement
Configuring Packet Bridging
Configuring bridged connections
8
9
Following are comparable RADIUS profiles for Site A:
SITEBGW Password="localpw", User-SErvice=Framed-User
Bridge-Ascend-1="Ascend", User-Service=Dialout-Framed-User
Following are comparable RADIUS profiles for Site B:
SITEAGW Password="remotepw", User-SErvice=Framed-User
Bridge-Ascend-1="Ascend", User-Service=Dialout-Framed-User
IPX bridged configurations
For NetWare WANs in which NetWare servers reside only on one side of the connection, you
can configure an IPX bridged connection. IPX bridging has special requirements for
facilitating NetWare client-server logins across the WAN and for preventing IPX RIP and SAP
broadcasts from keeping a bridged connection up indefinitely. These requirements vary,
depending on whether the local network supports NetWare servers, NetWare clients, or both.
The IPX bridging parameters
This section focuses only on IPX issues. It does not describe the general bridging parameters
explained earlier, although those parameters do apply to an IPX bridging connection.
Following are the related parameters (shown with sample settings):
Ethernet
Mod Config
Ethernet
Connections
14-12
Ethernet
Bridge Adrs
Bridge Adrs profile
Enet Adrs=0CFF1238FFFF
Net Adrs=0.0.0.0
Specify the number of the Connection profile to bring up a link to the remote network:
Ethernet Bridge Adrs Connection#=2
Exit the profile and, at the exit prompt, select the exit and accept option.
Framed-Protocol=PPP,
Ascend-Bridge=Bridge-Yes
Ascend-Bridge-Address="
Framed-Protocol=PPP,
Ascend-Bridge=Bridge-Yes
Ascend-Bridge-Address="
Ether options...
IPX Frame=802.2
Connection profile
Route IPX=No
IPX options...
Handle IPX=Client
Netware t/o=N/A
0C:FF:12:38:FF:FF Prof5 0.0.0.0 1"
0C:FF:12:38:FF:FF Prof2 0.0.0.0 1"
MAX 6000/3000 Network Configuration Guide
Advertisement
Table of Contents
