Lucent Technologies MAX 6000 Network Configuration Manual page 406

Figure 9-14. Example of a numbered interface
The numbered interface addresses are:
•
•
Figure 9-14 also shows an unnumbered interface. The 10.1.2.3/32 connection uses a
single system-based address for both the MAX itself and the dial-in user. To configure the
unnumbered and numbered interfaces:
1
2
3
4
5
6
Following is a comparable RADIUS profile:
numbered Password = "localpw"
MAX 6000/3000 Network Configuration Guide
MAX
10.2.3.4/24
10.5.6.7/24
IF Adrs=10.5.6.7/24
WAN Alias=10.5.6.8/24
Open Ethernet > Mod Config > Ether Options and verify that the IP Adrs parameter is set
to the IP address of the Ethernet interface of the MAX unit:
Ethernet
Mod Config
Ether options...
IP Adrs=10.2.3.4/24
Exit the profile and, at the exit prompt, select the exit and accept option.
Open the Connection profile and configure the required parameters, then open the IP
Options subprofile.
Set the LAN Adrs parameter to specify the IP address of the Ethernet interface of the
remote device:
Ethernet
Connections
numbered
IP options...
LAN Adrs=10.7.8.9/24
Set the WAN Alias parameter to specify the numbered interface address for the remote
device:
IP options...
WAN Alias=10.5.6.8/24
Exit the profile and, at the exit prompt, select the exit and accept option.
Service-Type = Framed-User,
Framed-Protocol = PPP,
Ascend-Route-IP = Route-IP-Yes,
Framed-IP-Address = 10.5.6.8,
Framed-IP-Netmask = 255.255.255.0,
10.1.2.3/32
WAN
10.7.8.9/24
10.5.6.8/24
Configuring IP Routing
Configuring WAN interfaces
9-45