Defining A Static Route To A Remote Subnet - Lucent Technologies MAX 6000 Network Configuration Manual

Configuring IP Routing
Configuring IP routes

Defining a static route to a remote subnet

If the connection does not enable RIP, the MAX does not learn about other networks or subnets
that might be reachable through the remote device. The remote network shown in Figure 9-15
is an example of such a network.
Figure 9-15. Two-hop connection that requires a static route when RIP is off
Site A
To enable the MAX to route to Site C without using RIP, you must configure a Static Rtes
profile similar to the following example:
Ethernet
Following is a RADIUS profile that shows both the default route and a route to the remote
subnet:
route-max-1 Password = "ascend", Service-Type = Outbound-User
Example of route preferences configuration
The procedure in the following example increases the preference value of RIP routes,
instructing the router to use a static route first if one exists:
1
2
3
9-60
MAX
Ethernet
IP Adrs=10.2.3.1/22
Static Rtes
Static Rtes profile 1
Name=SITEBGW
Active=Yes
Dest=10.4.5.0/22
Gateway=10.9.8.10
Metric=2
Preference=100
Private=Yes
Ospf-Cost=1
ASE-type=Type1
ASE-tag=c0000000
Framed-Route = "10.4.5.0/22 10.9.8.10"
Open Ethernet > Mod Config > Route Pref.
Set Rip Preference to 150:
Ethernet
Mod Config
Route Pref...
Rip Preference=150
Exit the profile and, at the exit prompt, select the exit and accept option.
Pipeline
WAN
Ethernet
10.9.8.10/22
MAX 6000/3000 Network Configuration Guide
Site B
Site C
Subnet=10.4.5.0/22