Icom ID-31A PLUS Advanced Manual page 59

4
D-STAR OPERATION
Entering new information into the repeater list
D Entering new information into the repeater list
Step 12. Setting the FM mode
L When Step 2. Selecting the communication type
is set to "DV Repeater" or "DV Simplex," this item is
not displayed
1 Select "MODE"
2 Select "FM" or "FM-N"
Step 13. Setting the tone
L When Step 2. Selecting the communication type
is set to "DV Repeater" or "DV Simplex," this item is
not displayed
1 Select "TONE"
2 Select an option
• OFF: Turn OFF the Tone function
• TONE: Select when the repeater requires an access
tone
• TSQL: Select when you want to use the tone squelch
operation in simplex.
Step 14. Selecting the repeater tone frequency
L When Step 2. Selecting the communication type
is set to "DV Repeater" or "DV Simplex," this item is
not displayed
L This setting is required when Step 13. Setting the
tone is set to "TONE" or "TSQL"
1 Select "REPEATER TONE"
2 Rotate [DIAL] to select the repeater tone
frequency, then push [ENT]
Step 15. Selecting the position data accuracy level
L When the Near Repeater Search function is not
1 Select "POSITION"
[Up]
2 Select the position data accuracy level
[ENT]
[Down]
Step 16. Entering the latitude
L This item is displayed only when Step 15.
1 Select "LATITUDE"
2 Rotate [DIAL] to enter the latitude
3 After entering, push [ENT]
Step 17. Entering the longitude
L This item is displayed only when Step 15.
1 Select "LONGITUDE"
2 Rotate [DIAL] to enter the longitude
3 After entering, push [ENT]
4-35
used, or the distance between your position and
a repeater is not needed, select "OFF," and go to
Step 18. Setting the UTC offset
• None: Select when the repeater has no position
data
• Approximate: Select when the entered position data is
approximate.
• Exact: Select when the entered position data is
exactly correct.
Selecting the position data accuracy level is set
to "Approximate" or "Exact."
L Push [CD] or [CS] to move the cursor
L To enter a north latitude, select "N," and to enter a
south latitude, select "S"
Selecting the position data accuracy level is set
to "Approximate" or "Exact."
L Push [CD] or [CS] to move the cursor
L To enter an east latitude longitude, select "E," and to
enter a west longitude, select "W"
► Continued on the next page