Icom ID-31A PLUS Advanced Manual page 123

8
SCANNING
VFO scan
1 Push [V/MHz] to enter the VFO mode
2 Push [FM/DV] to select the FM or DV mode
3 Hold down [SCAN] for 1 second
• Opens the Scan Type Select window
4 Select a scan type
▼
• The scan starts
• The decimal point and the selected Scan Type icon
blink
L When receiving a signal, the S-meter displays the
received signal strength
5 Hold down [SCAN] for 1 second
• Cancels the scan
L Holding down [CLR] also cancels the scan
D Scan type
• ALL: Full scan
• P-LINK0 ~ 9: Program Link scan
• P00 ~ 24: Program scan
• DUP: Duplex scan
(Displayed only when Duplex is set)
• TONE: Tone scan
(For the Tone Squelch scanning)
Information
L
• The frequencies that are set as a Skip channel
(PSKIP) are skipped during a scan (p 8-8)
• When Program Skip is set to "OFF," the Skip
channel frequencies are not skipped (p 11-5)
(MENU > Scan > Program Skip)
• To set a Program Link scan, see page 8-6
• To set a Program scan, see page 8-5
TIP:
• During a scan, rotate [DIAL] to change the
scanning direction
• During a scan, push [FM/DV] to select the Receive
mode
• During a scan, hold down [
function ON or OFF
• The scan continuously runs, even if you push
[MENU] or [QUICK] during a scan
• You can select a scan type by rotating [DIAL] while
holding down [SCAN] Release [SCAN] to start the
scan
8-4
] to turn the Lock