Scan Items - Icom ID-31A PLUS Advanced Manual

11
MENU SCREEN

Scan items

NOTE: The default settings shown below are for the USA transceiver version� The default settings may differ,
depending on your transceiver version� To return to your transceiver version's default settings, see page 11-3�
Pause Timer
MENU > Scan > Pause Timer
Select the Scan Pause Timer� When receiving a
signal, the scan pauses for this set period of time�
• 2sec ~ 20sec : When a signal is received, the scan
pauses for 2 ~ 20 seconds (in 2
second steps)�
• HOLD
: The scan pauses on a received
signal until the signal disappears�
Resume Timer
MENU > Scan > Resume Timer
Select the scan Resume Timer� When a received
signal disappears, the scan resumes for this set
period of time�
• 0sec: The scan resumes immediately after
the signal disappears�
• 1sec ~ 5sec: The scan resumes 1 ~ 5 seconds after
the signal disappears�
• HOLD: The scan remains paused for the
Pause Timer setting, even if the signal
disappears�
NOTE: Rotate [DIAL] to resume the scan� The
Resume Timer must be set shorter than the Pause
Timer, otherwise this timer does not work properly�
Temporary Skip Timer
MENU > Scan > Temporary Skip Timer
Set the Temporary Skip Timer to 5, 10, or 15 minutes�
The unwanted frequencies that are set as Skip
channels (PSKIP or SKIP) are skipped for this set
period of time during a scan�
This timer is activated for the VFO scan, Memory
scan, and DR scan�
Program Skip
MENU > Scan > Program Skip
Turn the Program Skip Scan function ON or OFF for a
VFO scan�
This function enables the transceiver to skip the
unwanted frequencies that are entered as a Memory
channel and is set to "PSKIP�" (p� 8-11)
• OFF: The transceiver scans all frequencies.
• ON: The transceiver does not scan frequencies set
as "PSKIP" frequencies�
(Default: 10sec)
(Default: 2sec)
(Default: 5min)
(Default: ON)
11-5
Bank Link
MENU > Scan > Bank Link
Select Banks to be scanned during a Bank Link Scan�
The Bank Link function scans all channels in the
selected banks�
Select a bank, A ~ Z, then push [ENT] to turn the Link
function ON or OFF�
• Displays "✔" when the function is set to ON�
L Push [QUICK] to quickly turn all the banks ON or OFF�
Program Link (Default: Refer to the illustration below)
MENU > Scan > Program Link
This item sets the Link function for 2 or more Program
Scan Edge channels to sequentially scan during a
Program Link scan� (p� 8-6) The Program Link scan
scans all frequencies in the scan range�
Default settings of the Program Link
0 ：
Program Link
Edit Name
1 ：
9 ：
Program Link number (0 to 9)
Information
L
• The PROGRAM LINK No� screen displays the frequency
range�
• You can add a Link setting by pushing [QUICK] when 2 or
more pairs of Program Scan Edge channels are entered�
• When only 1 pair of Program Scan Edge channels
is entered, or there is no pair of Program Scan Edge
channels (00A/00B ~ 24A/24B) left, "Add" is not displayed
after pushing [QUICK]�
(Default: A: ✔ ~ Z: ✔ )
Program Scan
Program Scan
lower edge
upper edge
(XXA)
(XXB)
00 ： 430.000−450.000
Delete
Blank
A pair of
Program Scan Edge channels