Icom ID-31A PLUS Advanced Manual page 4

INTRODUCTION
Entering and editing text
Controls used for text entry
Selects a character
Cancels
Moves the cursor
to the left
[ENT]
Sets
Selects a character
• To insert a text, move the cursor to a place to enter,
then rotate [DIAL] or push [RX→CS]/[DR].
• To clear a character, push [CLR].
• To consecutively clear characters, continuously hold
down [CLR].
To change the character type
1. When not selecting text, or an entered text is
[DIAL] (Rotate)
Selects a character 2. Rotate [DIAL] to select the character type, then
Clears the entry
Moves the cursor
to the right
Opens the Entry
Mode Select widow
iii
selected, push [QUICK].
push [ENT].
Character Selectable characters
type and symbols
AB
A to Z, 0 to 9, (space)
ab a to z, 0 to 9, (space)
12 0 to 9, (space)
! " # $ % & ' ( ) * + , - . / : ; < =
!"#
> ? @ [ \ ] ^ _ ` { | } ˜ (space)
TIP: When the character type is "AB" or "ab," and
while entering a character, push [QUICK] to select
upper case or lower case letters.
Character
conversion
A/a
A/a
–
–
▲ ▼ Push [QUICK]