Icom ID-31A PLUS Advanced Manual page 32

4
D-STAR OPERATION
"TO" (Destination) setting
"CQCQCQ," the destination repeater, or station call
sign must be set in "TO" when you make a call in the
DV mode You have 8 ways to set the destination
By rotating [DIAL]
Rotate [DIAL] to select the repeater or Your Call
Sign that is displayed on the DR screen (This
operation is disabled when "CQCQCQ" is set)
• To make a Local Area CQ call
"Local CQ" setting (p 4-9)
Set "CQCQCQ" in "TO" (Destination)
• To make a Gateway CQ call
"Gateway CQ" setting (p 4-9)
Select a repeater from the repeater List, if you want
to make a Gateway call
• To make a call to a specific station
"Your Call Sign" setting (p 4-10)
Select the station call sign in the Your Call Sign
memory
• To make a call through a Reflector
"Reflector" setting (p 4-14)
Select a reflector you want to call through.
• To select from RX History
Setting from RX History (p 4-10)
When you receive a call, repeater or caller station
data is saved in RX History
Select the destination from the record
• To select from TX History
Setting from TX History (p 4-11)
When you make a call, the destination repeater or
called station data is saved in TX History
Select the destination from the record
• To directly enter the destination station call sign
Direct Input (UR) (p 4-11)
Directly enter the destination station's call sign
• To directly enter the destination repeater call sign
Direct Input (RPT) (p 4-12)
Directly enter the destination repeater's call sign
TIP: After you receive the individual station or
repeater's signal, the call sign can be captured
by holding down the Call Sign Capture key
([RX→CS]), and you can quickly and easily reply to
a call
4-8
TO SELECT screen
TIP: How to change the
repeater group:
When "Local CQ" or "Gateway
CQ" is selected, you can change
the repeater group
To change the repeater group on
the DR screen, push [QUICK],
then select "Group Select"