Transferring The Setting From The Memory Card - Siemens SINAMICS G120 Operating Instructions Manual

7.1.3

Transferring the setting from the memory card

Automatically transferring
Precondition
The inverter power supply has been switched off.
Procedure
Proceed as follows to automatically transfer your settings:
1. Insert the memory card into the inverter.
2. Then switch on the inverter power supply.
If there is valid parameter data on the memory card, then the inverter accepts the data from
the memory card.
Manually transferring
Requirements
● The inverter power supply has been switched on.
● No memory card is inserted in the inverter.
Procedure with STARTER
Proceed as follows to transfer settings from a memory card to the inverter:
1. Go online and in your drive, select the "Drive Navigator".
2. Select the "Commissioning" button.
3. Select the button to transfer the data from the memory card to the inverter.
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Saving the settings and series commissioning
7.1 Backing up and transferring settings using a memory card
375