Analog Input As Setpoint Source - Siemens SINAMICS G120 Operating Instructions Manual

6.16.1

Analog input as setpoint source

Interconnecting an analog input
If you have selected a pre-assignment without a function of the analog input, then you must
interconnect the parameter of the main setpoint with an analog input.
Figure 6-22
Table 6-31
Parameter
p1070 = 755[0]
p1075 = 755[0]
See also
Analog inputs (Page 203)
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
Example: Analog input 0 as setpoint source
Setting with analog input 0 as setpoint source
Remark
Main setpoint
Interconnect the main setpoint with analog input 0
Additional setpoint
Interconnect the additional setpoint with analog input 0
Advanced commissioning
6.16 Setpoints
259