Siemens SINAMICS G120 Operating Instructions Manual page 546

Low voltage converters built-in and wall mounting units with cu230p-2 control units
Hide thumbs Also See for SINAMICS G120:
Table of Contents

Advertisement

Index
PROFIenergy, 137
Protection functions, 193
Pt1000 sensor, 325
PTC sensor, 325
Pulse cancelation, 221
Pulse enable, 221, 235, 238, 242
Pulse frequency, 323, 324, 452, 508
Pulse suppression, 235, 238, 242
Pump, 36, 37, 38, 157, 161, 169, 180, 183, 185
PZD (process data), 217
Q
Questions, 540
Quick stop, 195
R
Ramp-down time, 271
Ramp-function generator, 266
Ramp-up time, 271
RDY (Ready), 396
Ready, 196
Ready to start, 196
Real-time clock, 293
Regenerative feedback, 320
Regenerative operation, 311
Reset
Parameter, 189
Reversing, 266
Rounding, 272
Rounding OFF3, 272
RTC (Real-Time Clock), 293, 295
S
S7 communication, 137
Saw, 313, 316
Scaling
Analog input, 204
Analog output, 207
SD (memory card), 370
Formatting, 370
MMC, 370
Sequence control, 195
Series commissioning, 369
Setpoint processing, 192, 266
Setpoint source, 192
Selecting, 259, 260, 261
Settling time, 157, 161, 169, 180, 185
Short-circuit monitoring, 325, 326
546
Signal interconnection, 533
Signal states, 396
Sine-wave filter, 51, 296
SIZER, 539
Skip frequency band, 266
Slip compensation, 297
Speed
change with BOP-2, 525
Limiting, 266
Speed control, 306
Square-law characteristic, 300, 301
Standard time, 293
Standards
EN 61800-3, 31
Star connection (Y), 105
Startdrive, 381
STARTER, 381
Download, 146
Starting behavior
Optimization, 302, 304
Starting current, 298
State overview, 195
Status word
Status word 1, 222, 243
Status word 3, 224
Storage medium, 369
STW1 (control word 1), 220, 235, 237, 241
Subindex, 228
Suggestions for improvement manual, 541
Support, 540
Switch off
Motor, 195
OFF1 command, 195
OFF2 command, 195
OFF3 command, 195
Switch on
Motor, 195
ON command, 195
Switching on inhibited, 221, 242
Switching-on a motor with BOP-2, 525
Switch-on inhibit, 196, 235, 238
Symbols, 25
System runtime, 398
T
Technical data
Control Unit, 435, 436, 437
General, 464
Technology controller, 223, 255, 274
Telegram
Extending, 231
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Sinamics g120p

Table of Contents