Siemens SINAMICS G120 Operating Instructions Manual page 516

Appendix
A.1 New and extended functions
Function
9 Setting option for two output reactors using parameter p0235 at the SI‐
NAMICS G120C and SINAMICS G120 with PM240-2 FSD ... FSF Power
Module
10 Efficiency-optimized operation of induction motors
Improved method "Efficiency optimization 2"
11 New setting option for the "Technology application" p0500 = 5 during quick
commissioning
12 Expansion of the available PROFIdrive telegrams in the SINAMICS G120C
to include telegram 350
13 An SSI encoder can be parameterized as motor encoder
14 Expansion of the "Basic positioner" function to include the feedback signal
from traversing blocks to the higher-level control system
15 Expansion to include a feedback signal if a memory card is not inserted in
the inverter:
● Parameter r9401 as BiCo parameter for the optional feedback signal to
the higher-level control system.
● New alarm A01101
16 Expansion of the "End stop control" function on the following inverters:
● SINAMICS G120
● SINAMICS G120C
● SINAMICS G120D
17 Expansion of the technology controller to include the following functions:
● Gain K and integral time T
P
● The system deviation can be used as adaptation signal
18 Expansion to the torque limiting for SINAMICS G120 inverters with
CU230P‑2 Control Unit
516
can be adapted.
N
Changes in the current manual (Page 5)
- ✓
✓ ✓
✓ ✓
- ✓
- -
- -
✓ ✓
✓ ✓
- -
✓ ✓
Converter with the CU230P-2 Control Units
Operating Instructions, 09/2017, FW V4.7 SP9, A5E34257946B AE
SINAMICS
G120 G120D
✓ ✓ ✓ ✓ - -
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ - -
- - - ✓ - ✓
- - - ✓ - ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ ✓ ✓ ✓ ✓ ✓
✓ - ✓ - - -
✓ ✓ ✓ ✓ ✓ ✓
-
✓
✓
-
-
-
✓
-
-
✓