Dialing In To A Vrr To Start Recording - Polycom RSS 4000 User Manual

Polycom RSS 4000 System User Guide
74
Polycom RMX series systems that support the Recording Link can be
connected to the multipoint meeting room as a participant as well.
The multipoint recording has the following limitations:
• The quick code is not supported for archives generated from the multipoint
recordings for playback.
• Participants in a multipoint recording cannot view archives stored in the system
through the TV interface.
You can create a multipoint recording room by defining a multipoint VRR in
the Polycom® RSS™ 4000 system. Dialing into a multipoint VRR sets up a
multipoint recording room between the two sites.
To define a multipoint VRR:
Go to VRR > VRRs.
1
In the ACTIONS list, click Add.
2
3 Click Advanced Property tab to configure the following settings.
Parameter Description
Enable Multipoint Enable multipoint VRR.
VRR
You can select one of the layout:
•
•
For other options in the page, refer to
4
5 Click OK to complete the configuration.

Dialing in to a VRR to Start Recording

You can start recording using a user-defined VRR in one of the following two
ways:
• Dialing the VRR through an endpoint remote control.
Lecture Mode: Displays the lecture in the full screen.
When a participant keeps speaking for 10 seconds, the
system elects him or her as a lecturer. The lecturer switches
between the two sites through the audio activation.
CP Mode: Displays the video of two sites side by side on
the screen.
VRRs
Virtual Recording Room (VRR)
on page 69.
Polycom, Inc.