Appendix B - Telnet And Terminal Commands; Before You Start; Configuring A Terminal Program - Polycom RSS 4000 User Manual

Before You Start

Appendix B – Telnet and Terminal
Commands
Before You Start

Configuring a Terminal Program

Polycom, Inc.
The Polycom RSS 4000 system supports system debugging from the command
line. You can select one of the following methods:
• Connect your computer to the serial port of the RSS system, then use a
terminal emulation program, such as HyperTerminal, for system
debugging.
• Configure the system by using Telnet.
Both methods use the same command format.
Before you can use a hyperterminal program, or Telnet service to configure
your RSS system, you need to configure the application first.
You need to configure the port settings, such as:
• Port: COM1 (basing on the port used)
• Baud rate: 115,200 bps
• Data bits: 8 bits
• Parity bit: None
• Stop bit: 1
Furthermore, you may need to set some other parameters based on the
simulation software used:
• No echo for local input
• The settings for the DEL and Backspace keys
• Enter/New line
• The simulation type for the endpoint: Automatic or ANSI
Appendix B – Telnet and Terminal Commands
115