Resetting Password; Restoring System Configuration; Cleaning Activation Key; Telnet Settings - Polycom RSS 4000 User Manual

Command Introduction
Polycom, Inc.

Resetting Password

Type reset password after the prompt # to restore the administrator user
password for Web login to the default password (admin).
The system will show the prompt message Are you sure?. Type Y to proceed,
or type N to cancel.

Restoring System Configuration

Type reset config after the prompt # to restore the following system
configurations to the default value:
• System Config
— IP Setting
— System time
— Recording Setting
— Security setting (Ports and security policy)
— Service Setting
— Signaling Setting
• Admin
— UI Customization (System name and default endpoint menu
language)
— Disk Warning
The system will show the prompt message Are you sure?. Type Y to proceed,
or type N to cancel.
After resetting the system configuration, the system must be restarted in order
for the new settings to take effect.

Cleaning Activation Key

Type cleankey after the prompt # to remove the existing activation key. This
command is used to deactivate the RSS™ 4000 system.
The system will show the prompt message Are you sure?. Type Y to proceed,
or type N to cancel.

Telnet Settings

Type telnet {on | off} after the prompt # to turn on/off the telnet session. For
example, enter telnet on to enable telnet function.
Appendix B – Telnet and Terminal Commands
119