Configuring The Quicktime Streaming Server - Polycom RSS 4000 User Manual

Polycom RSS 4000 System User Guide

Configuring the QuickTime Streaming Server

130
7 Click OK.
You cannot create two external servers with the same Server type, IP, Port, Application
Name, and Publishing Point Name. This is because the Polycom RSS 4000 system
does not allow publishing two streams to the same publish point to avoid overwriting
the first stream by the second one.
To configure a template and VRR for use with the IIS7 server, see
VRR for use with an external server:
To configure the QuickTime Streaming server:
1 Install QuickTime server.
Launch the Server Admin application, click + to add a
2
QuickTimeStreaming Service.
3 Click Settings to view the configurations.
4 If QuickTime server authentication is needed, enter the user name and
password in Accept incoming broadcasts.
Install and configure an FTP server. The FTP server shares the
5
<QuickTime Server directory>/Movies directory.
You need to grant the user at least the Read, Write, and Create Directories
authorities.
Start the QuickTime Streaming server. Navigate to /usr/sbin,
6
./QuickTimeStreamingServer.
To configure the RSS 4000 system for work with the QuickTime Streaming:
Go to External Servers > Media Servers.
1
On the ACTION panel, click Add.
2
3 Configure the following basic settings.
Parameter
Server Name
on page 126.
Description
Specify the name of your QuickTime Streaming
Server.
To create a
Polycom, Inc.