(Optional) Configuring The Gatekeeper Settings - Polycom RSS 4000 User Manual

System Initial Configuration

(Optional) Configuring the Gatekeeper Settings

Polycom, Inc.
12 Click Update. The system restarts to apply your changes.
13 Change your computer's IP address back to its original address.
This is to ensure your computer and the Polycom RSS 4000 system are
within the same network.
To change the IP address using the RS-232 Console:
Connect your computer to the RS-232 port of the Polycom RSS 4000
1
system with a serial port cable and activate the console port (115200, 8
bits).
2 After you log in to the console port, enter the default password
POLYCOM to enter the system.
Enter ? or help after the prompt "#" and the system displays available
3
command information.
4 Change the IP address using the command in the format below:
— set lan1 ip {dhcp | static <ip > netmask <mask > gw <gateway > }
For example, to set the IP address of LAN1 port to 172.21.103.29, subnet
mask to 255.255.255.0 and gateway address to 172.21.103.254, enter the
following command:
Please note:
• The same steps are also applicable for a Telnet connection.
• Only one console (Telnet or RS-232) can be connected at a time.
If a gatekeeper is configured on your network, register the Polycom RSS 4000
system to the gatekeeper to simplify calling.
To register the system to the gatekeeper:
In the Internet Explorer's address line, enter the system's IP address in
1
this format: https://<system IP
Go to System Config > Signaling Settings > H.323.
2
3 Select Register To Gatekeeper.
:
.
address>/rss.
Getting Started
9