Polycom RSS 4000 User Manual page 68

Polycom RSS 4000 System User Guide
60
2 Select Restart or Shut Down.
• All current configuration and recorded archives are cleared after the system is
restored to the default configuration.
• Before the system restarts to complete restoring to the factory default configuration,
please remove the USB device connected to the system. Otherwise, after the system
restarts, you receive a default configuration setting dialog box when you try to log
in to the Admin UI.
To restore the system to the factory default status:
Only the software version and system IP address can be reserved. You need
an USB storage device to restore the system to the default settings. There is
no requirement on USB device type and files it stores.
Connect the USB storage device to the USB port on the back panel of the
1
system.
2 Log in to the Admin UI, and then go to Admin > Restart/Shut Down,
click Restart.
After the system restarts, log in to the system's Admin UI again.
3
Configure the following settings:
4
Parameter
Build-in Account
Password
Confirm Password
Keep current IP setting
5 Click Next. If you want to continue, click YES, and then click OK. Click
Back to go back to the setting box.
Remove the USB storage device before the system restarts to complete
6
restoration.
Description
System built-in default administrator account. The user name
and password can be modified here.
Specify the confirm password.
Specify whether or not the default configuration restoration
reserves the current system IP address.
If not selected, the system restores the default IP settings:
• LAN1IP address: 192.168.1.254
• Subnet mask: 255.255.255.0
• Gateway: 192.168.1.1
System Administration
Polycom, Inc.