Installation; Unpacking And Installing - Polycom RSS 4000 User Manual

Polycom RSS 4000 System User Guide

Installation

Unpacking and Installing

2
Follow these rules to ensure general safety:
• Keep the area around the Polycom RSS 4000 unit clean, free of clutter, and
well ventilated.
• Choose a suitable location for the equipment rack that will hold the
Polycom RSS 4000 unit and is near a grounded power outlet.
• Use a regulating UPS (uninterruptible power supply) to protect the
Polycom RSS 4000 unit from power surges and voltage spikes, and to keep
it operating in case of a power failure.
To unpack and install the system:
1 Inspect the package to make sure that it has not been damaged.
2 Open the package and check the items included. The following items
should be included:
— One Polycom RSS 4000 server unit
— Two power cables
— Two RJ-45 network cables
— One DB9 serial port cable
— A CD
— A license and a user registration card
3 Take all items out of the package and check to see if any of them is in poor
condition.
If you find damage, file a claim with the delivery carrier. Polycom is not responsible
for damage sustained during shipment of this product.
To install the system:
Place the Polycom RSS 4000 unit on a stable flat surface in the selected
1
location.
Insert each power cable connector into the rear of the RSS 4000 system
2
and connect each to an appropriately rated socket outlet.
The Polycom RSS 4000 unit is supplied with two power cables. BOTH
power cables should be connected to the main power supply during
normal operation.
Installation
Polycom, Inc.