Polycom RSS 4000 User Manual page 16

Polycom RSS 4000 System User Guide
8
MTU
LAN Speed
NAT Public (WAN)
Address
10 Configure the following general settings:
Parameter
Enable Destination
Unreachable Message
Host Name
Domain
Default IPv6 Gateway
Default IPv4 Gateway
Preferred DNS Server
Alternate DNS Server
11 Click Add to add static routes. You need to enter the following
information for each route:
Parameter
Destination
Gateway
Subnet Mask
Specify the MTU (Maximum Transmission Unit) size.
Specify the speed or duplex modes for the LAN port. Select
Auto to let the system set the speed automatically.
Note: When setting the LAN port speed, contact your
network administrator to ensure that the switch link rate
matches the system port speed.
Specify whether to enable the NAT (Network Address
Translation).
NAT environments use private internal IP addresses for
devices within the network, while using one external IP
address to allow devices inside the LAN to communicate
with other devices outside the LAN.
Description
Specify whether to allow the system to forward ICMP
destination unreachable messages that come from other
network devices when the system is configured to serve as a
router.
Specify the host name of the system.
Specify the domain name of the system.
Specify the address of the interface to use for accessing the
IPv6 gateway.
Specify the address of the interface to use for accessing the
IPv4 gateway.
Specify the preferred DNS server address for the system to
resolve domain names.
Specify the alternate DNS server address for the system to
resolve domain names.
Description
Specify the IP address of the destination network.
Specify the IP address of the gateway to access the
destination network.
Specify the subnet mask for the destination network.
System Initial Configuration
Polycom, Inc.