Miscellaneous System Commands; System:preset; System:version; System:key <Nrf - Keithley 2750 User Manual

Model 2750 Multimeter/Switch System User's Manual

Miscellaneous SYSTem commands

SYSTem commands not covered in other sections of the manual are documented here.
Table 15-7
information.

SYSTem:PRESet

Returns the instrument to states optimized for front panel operation. SYSTem:PRESet
defaults are listed in the SCPI tables in
NOTE

SYSTem:VERSion

Read the version of the SCPI standard being used by Model 2750. Example response mes-
sage: 1996.0.
SYSTem:KEY <NRf>
Parameters
Parameters
This command is used to simulate front panel key presses. For example, to select the volts
measurement function, send the following command to simulate pressing the "DCV" key:
SYSTem:KEY 2. The key-press codes are also shown in
lists all SYSTem commands and provides references on where to find more
For RS-232 operation (and in some cases, GPIB operation), *OPC or *OPC?
should be used with *SYST:PRES, which is a slow responding command. Details
on *OPC and *OPC? are provided in
1 = SHIFT key
2 = DCV key
3 = ACV key
4 = DCI key
5 = ACI key
6 = Ω2 key
7 = Ω4 key
15 = Cursor right arrow key
16 = TEMP key
17 = LOCAL key
18 = EX TRIG key
19 = TRIG key
20 = STORE key
21 = RECALL key
22 = FILTER key
23 = REL key
FORMat and Misc SYSTem Commands
Section 15.
Section 12.
8 =
9 =
10 =
11 =
12 =
13 =
14 =
24 =
25 =
26 =
27 =
28 =
29 =
30 =
31 =
32 =
Figure
14-7
FREQ key
-------
-------
RANGE up arrow key
AUTO key
RANGE down arrow key
ENTER key
Cursor left arrow key
-------
OPEN key
CLOSE key
STEP key
SCAN key
DIGITS key
RATE key
EXIT key
14-3.