Keithley 2750 User Manual page 356

Model 2750 Multimeter/Switch System User's Manual
Table 15-5 (continued)
SENSe command summary
Command
:DELay <NRf> [, <clist>]
:DELay? [<clist>]
[:STATe] <b> [, <clist>]
[:STATe]? [, <clist>]
:VOLTage[:DC]
:APERture <NRf>
[, <clist>]
:APERture? [<clist>]
:NPLCycles <n> [, <clist>]
:NPLCycles? [<clist>]
:RANGe
[:UPPer] <n> [, <clist>]
[:UPPer]? [<clist>]
:AUTO <b> [, <clist>]
:AUTO? [<clist>]
:DIGits <n> [, <clist>]
:DIGits? [<clist>]
:REFerence <n> [, <clist>]
:STATe <b> [, <clist>]
:STATe? [<clist>]
:ACQuire [, <clist>]
:REFerence? [<clist>]
:AVERage
:TCONtrol <name>
:TCONtrol?
:WINDow <NRf>
:WINDow?
:COUNt <n> [, <clist>]
:COUNt? [<clist>]
[:STATe] <b> [, <clist>]
[:STATe]? [<clist>]
:IDIVider <b>
:IDIVider?
Description
Set delay between the two measurements
in seconds (0 to 99999.999).
Query delay.
Enable or disable channel ratio.
Query state of channel ratio.
Path to configure DC voltage.
Set integration rate in seconds (60Hz,
1.67e-4 to 1; 50Hz, 2e-4 to 1).
Query aperture integration rate.
Set integration rate in line cycles (60Hz,
0.01 to 60; 50Hz, 0.01 to 50).
Query line cycle integration rate.
Path to set measurement range:
Select range (0 to 1010).
Query range.
Enable or disable auto range.
Query state of auto range.
Specify measurement resolution (4 to 7).
Query resolution.
Specify reference (-1010 to 1010).
Enable or disable reference.
Query state of reference.
Use input signal as reference.
Query reference value.
Path to configure and control filter:
Select filter type: (MOVing or REPeat).
Query filter type.
Set filter window in % of range
(0 to 10).
Query filter window.
Specify filter count (1 to 100).
Query filter count.
Enable or disable filter.
Query state of digital filter.
Enable or disable 10MΩ input divider.
Query state of input divider.
SCPI Reference Tables
Default
parameter
0.5
1
OFF
(Note 2)
5.0
1000
ON
7
0
OFF
(Note 3)
0.1
10
(Note 4)
OFF
15-9
Ref SCPI
Sec 3
Sec 4
Sec 4
Sec 4
Sec 4
Sec 5
Sec 4
Sec 3