Scan Configuration - Keithley 2750 User Manual

Model 2750 Multimeter/Switch System User's Manual

Scan configuration

A scan is configured from the scan configuration menu which is accessed by pressing
SHIFT and then CONFIG.
entering the menu structure you can configure a simple scan, an advanced scan, or reset
the configuration to the default setup for a simple scan. Refer to the flowchart in
Figure 7-3
scan."
NOTE
Figure 7-3
Scan configuration flowchart
Simple
Min Chan
Max Chan
Timer?
Rdg Cnt
NOTE
Figure 7-3
for the following discussions on
Only a sequential scan can be configured from the front panel. For a sequential
scan, the scan proceeds from the lowest numbered channel to the highest.
Non-sequential (backward) scanning is only intended to be performed using
remote programming. Unexpected results may occur if a non-sequential scan is
run from the front panel.
For more information, see
sequential scans," page
SHIFT
CONFIG
Advanced
Setup
Imm Scan?
Timer?
Rdg Cnt
The instrument is always configured to run a scan. On power-up, each available
channel uses the power-on default setup. For example, for factory power-on
default settings, and two Model 7700s installed, the instrument will scan chan-
nels 101 through 220 when the scan is run. See
on default settings.
shows the basic flowchart to configure a scan. After
"Scan reset,"
"Scanning fundamentals
7-3.
Reset
Scanning
"Simple scan," and "Advanced
– Sequential and non-
Section 1 for details on power-
7-11