System Commands - Keithley S46 Instruction Manual

S46/S46T Microwave Switch System Instruction Manual
Description
Query
:CLEar
Description
Query

SYSTem commands

A list of the SYSTem commands is contained in
subsystem contains miscellaneous commands.
The :SYSTem command path is required to access all commands contained in the
:SYSTem subsystem command set. To send any of the commands contained in the
:SYSTem subsystem command set, include the command path before the command. For
an example, see the description of the specific command.
Table 3-5
:SYSTem subsystem command set
Commands
:SYSTem
:ERRor?
:VERSion?
:CLEar
:SNUMber?
Use this command to specify status and error messages disabled for the
error queue. On power-up, status messages are not enabled and
therefore are prevented from going into the queue. All other error
messages are enabled and will go into the error queue as they occur
unless disabled. For example, to disable the -110, -140, and -222
messages, send:
:STAT:QUE:DIS (-110,-140,-222)
This query command is used to return a list of the presently disabled
error messages.
Use this command to clear all messages from the error queue. For
example, to clear all messages from the error queue, send:
:STAT:QUE:CLE
No query form of this command exists.
Description
Root path to :SYSTem subsystem commands.
Query system error queue.
Query SCPI version.
Clear messages in error queue.
Query the serial number only.
Operation
Clear all messages from the error queue
Table 3-5. The SYSTem command
S46-901-01 Rev. C / January 2006
3-13