3-6
Basic DMM Operation
Remote programming
Autozero and LSYNC commands
The commands to control display resolution (digits) are listed in
Table 3-1
Autozero and LSYNC commands
SYSTem:AZERo:STATe <b>
Line synchronization command
SYSTem:LSYNc[:STATe] <b> Enable or disable LSYNC; <b> = ON or
* After enabling autozero, you can update the internal reference points immediately by setting the integration
rate to 0.01 PLC and then back to the desired setting (see NPLC commands in
autozero and LSYNC
—
Commands
Autozero command*
Model 2750 Multimeter/Switch System User's Manual
Description
Enable or disable autozero; <b> = ON or
OFF
OFF
Table
3-1.
Default
ON
OFF
Section
4).