Common Commands; Ieee-488 Operation; Ieee-488.2 Common Commands And Queries - Keithley 7002-HD User Manual

Model 7002-HD User's Manual

Common commands

Table 5-1
are presented in alphabetical order.
Table 5-1

IEEE-488.2 common commands and queries

Mnemonic
*CLS Clear status
*ESE <NRf> Event status
enable command
*ESE? Event status enable query
*ESR? Event status
register query
*IDN? Identification query
*OPC Operation complete
command
*OPC? Operation complete query
*OPT? Option identification query
*RCL <NRf> Recall command
*RST Reset command
*SAV <NRf> Save command
summarizes the common commands used by the Model 7002-HD and
Name
Return to
Description
Clears all event registers, and Error Queue.
Sets the contents of the Standard Event Status
Enable Register.
Request the programmed value of the Standard
Event Status Enable Register.
Request the programmed value of the Standard
Event Status Register and clears it.
Request the manufacturer, model number, serial
number, and firmware revision levels of the unit.
Sets the Operation Complete bit in the Standard
Event Status Register after all pending com-
mands have been executed.
Places an ASCII "1" into the output queue when
all pending selected device operations have
been completed.
Request the assigned model number for all slots.
Returns the Model 7002-HD to the setup config-
uration stored in the designated memory loca-
tion.
Returns the Model 7002-HD to the *RST default
conditions.
Saves the current setup configuration to the des-
ignated memory location.
Section 5 topics

IEEE-488 Operation

5-9