Remote Programming - Range - Keithley 2750 User Manual

4-4 Range, Digits, Rate, Bandwidth, and Filter
Remote programming — range
Range commands
The commands to set range are listed in
mands follow the table.
NOTE
Table 4-2
Range commands
Commands
[SENSe[1]]
:VOLTage[:DC]:RANGe <n> [, <clist>]
:VOLTage[:DC]:RANGe:AUTO <b>
[, <clist>]
:VOLTage:AC:RANGe <n> [, <clist>]
:VOLTage:AC:RANGe:AUTO <b> [, <clist>]
:CURRent[:DC]:RANGe <n> [, <clist>]
:CURRent[:DC]:RANGe:AUTO <b>
[, <clist>]
:CURRent:AC:RANGe <n> [, <clist>]
:CURRent:AC:RANGe:AUTO <b> [,
<clist>]
:RESistance:RANGe <n> [, <clist>]
:RESistance:RANGe:AUTO <b> [, <clist>]
:FRESistance:RANGe <n> [, <clist>]
:FRESistance:RANGe:AUTO <b> [, <clist>]
Channel list parameter:
<clist> = (@SCH)
where: S = Mainframe slot number (1, 2, 3, 4 or 5)
CH = Switching module channel number (must be 2 digits)
Examples: (@101) = Slot 1, Channel 1
(@101, 203) = Slot 1, Channel 1 and Slot 2, Channel 3
(@101:110) = Slot 1, Channels 1 through 10
1. The <clist> parameter is used to configure one or more channels for a scan. Each channel in the <clist> must be set to the function
specified by the range command. If not, a conflict error (-221) will occur. For example, VOLTage:AC:RANGe 1, (@101) is only
valid if scan channel 101 is set for the ACV function.
2. [:DC] is optional for the commands to set DCV and DCI range.
Query commands and some optional command words are not included in
Table 4-2. All commands for the SENSe subsystem are provided in
1, 2
Optional root command.
Model 2750 Multimeter/Switch System User's Manual
Table 4-2. Additional information on these com-
Description
Select DCV range; <n> = 0 to 1010 (V).
Control DCV auto range; <b> = ON or OFF. ON
Select ACV range; <n> = 0 to 757.5 (V).
Control ACV auto range; <b> = ON or OFF. ON
Select DCI range; <n> = 0 to 3 (A).
Control DCI auto range; <b> = ON or OFF. ON
Select ACI range; <n> = 0 to 3 (A).
Control ACI auto range; <b> = ON or OFF. ON
Select Ω2 range; <n> = 0 to 120e6 (Ω).
Control Ω2 auto range; <b> = ON or OFF.
Select Ω4 range; <n> = 0 to 120e6 (Ω).
Control Ω4 auto range; <b> = ON or OFF.
Table 15-5.
Default
1000
750
3
3
120e6
ON
120e6
ON