System Configuration - Keithley S46 Installation Manual

Microwave switch system

Hide thumbs Also See for S46:

System configuration

After installing the new relays, you must program the S46 for the new relay configuration with the following

command:

:ROUT:CONF:CPOL <clist>

<clist> is defined as follows:

clist = (@0 | 3-6, 0 | 3-6, 0 | 3-6, 0 | 3-6, 0 | 1, ... 0 | 1)

Relay:

NOTE All switch locations must be included in the <clist> whether or not all

See Section 3 of the S46 Instruction Manual (document number S46-901-01) for detailed programming

information.

... 8

locations are populated. The numeric value (1 or 3-6) indicates the

number of throws, while a value of 0 indicates that a location is not

populated.

For example, if RELAY A and RELAY B are SP6T, RELAY 1 and RELAY

2 are SPDTs, and all other locations are not populated, the command

syntax would be:

:ROUT:CONF:CPOL (@6,6,0,0,1,1,0,0,0,0,0,0)

PA-912 Rev. B / 11-05