Reference Tables - Keithley 2750 User Manual

15-2 SCPI Reference Tables

Reference tables

Table 15-1
Model 7700 switching module.
NOTE
Table 15-1
Table 15-2
Table 15-3
Table 15-4
Table 15-5
Table 15-6
Table 15-7
Table 15-8
Table 15-9
Table 15-10
General notes:
•
•
•
•
•
•
•
through Table 15-10
The commands listed in the following tables pertain to operation of the Model
2750 and the Model 7700 switching module. For commands that are unique to
operation of other switching modules, refer to the packing list that was included
with the module.
— CALCulate command summary
— DISPlay command summary
— FORMat command summary
— ROUTe command summary
— SENSe command summary
— STATus command summary
— SYSTem command summary
— TRACe command summary
— Trigger command summary
— UNIT command summary
Brackets ([ ]) are used to denote optional character sets. These optional characters
do not have to be included in the program message. Do not use brackets in the pro-
gram message.
Angle brackets (< >) are used to indicate parameter type. Do not use angle brackets
in the program message.
The Boolean parameter (<b>) is used to enable or disable an instrument operation.
1 or ON enables the operation, and 0 or OFF disables the operation.
Upper case characters indicate the short-form version for each command word.
Default Parameter — Listed parameters are both the *RST and SYSTem:PRESet
defaults, unless noted otherwise. Parameter notes are located at the end of each
table.
Ref — The reference column indicates where to find detailed information on the
command(s).
SCPI — A checkmark ( ) indicates that the command and its parameters are SCPI
confirmed. An unmarked command indicates that it is an SCPI command, but does
not conform to the SCPI standard set of commands. It is not a recognized
command by the SCPI consortium. SCPI confirmed commands that use one or
more non-SCPI parameters are explained by notes.
Model 2750 Multimeter/Switch System User's Manual
summarize the commands to operate the Model 2750 and