Vertical WAVE IP 2500 Installation Manual page 98

Wave IP 2500 Installation Guide
8#/ OQFWNG FGVGEVKQP KPFKECVQTU
After powering on the Wave IP 2500, while bootup is still in Redboot mode (indicated by a red
ISC1 Status LED1), the following settings indicate whether or not a Vertical Application
Module (VAM) was detected. on the ISC1.
5VCVWU
VAM detected.
VAM not detected.
4GUGVVKPI HCEVQT[ FGHCWNV +2 CFFTGUU KPFKECVQTU
After resetting the ISC1 and VAM IP address settings to the factory defaults as described on
page 4-16, the following status indicator LED sequence indicates that the procedure was
successful.
5VCVWU
Red button press detected at power on.
Programming factory default IP
settings.
Redboot started. Factory default IP
address settings have been applied.
$
5[UVGO
5VCVWU .'&
Red
Red
.'&
Red
Red
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
5[UVGO +5% 4GF
5VCVWU .'&U .'&

Any color Red
Any color Red
.'& .'&
off off
off off
+5% )TGGP
.'&
off
Green
.'&
Red
Green