Vertical WAVE IP 2500 Installation Manual page 39

8. Reconnect the Wave IP 2500 to power.
+PUVCNNKPI GZRCPUKQP OQFWNGU CPF ECTFU
This section provides guidelines for installing all modules and cards. See "Connecting modules
and cards" on page 3-16 for information on connecting trunks, stations, and other devices to
specific modules and cards after you have installed them.
Caution:
The Wave IP 2500's analog station interface is not designed to withstand surges
commonly associated with wires that are exposed to the external environment. Do not route the
wires connecting analog station cards or modules to stations outside the building where the
Wave IP 2500 is located.
To install a Media Resource Module, see the instructions starting on page 3-14.
Note:
6Q KPUVCNN OQFWNGU CPF ECTFU
1. Unplug the Wave IP 2500's power cord and the power cords of all EXUs, but do not
disconnect the grounding wires.
2. Remove the blank module or universal slot faceplate.
3. Insert modules and cards carefully.
• Note the position of the circuit board installation guides—there are 2 guides per
slot:
•
•
• Note the position of slot connectors:
•
•
4. Seat the module or card properly for good electrical connection. Engage the black
insertion lever, and tighten all faceplate mounting screws.
5. To install a partial-width module in a full-width universal slot, use a Wave IP 2500
module converter. First, screw the module into the converter, and then insert the
converter into the universal slot.
Modules align with the bottom guide.
Cards align with the top guide.
The ISC1 slot and module slots have a single slot connector.
Universal slots have 2 slot connectors:
• Modules connector to the bottom slot connector.
• Cards connect to the top slot connector
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide