Vertical WAVE IP 2500 Installation Manual page 59
Hide thumbs
Also See for WAVE IP 2500:
- Hardware reference manual (210 pages) ,
- Installation manual (236 pages)
Table of Contents
Advertisement
3.
In the IP Network Settings dialog box, select the Integrated Services Card from the
Network Interfaces dropdown list.
4.
On the IP Address tab, accept the factory defaults for the following settings, or assign
different ones.
•
IP Address: IP address of the ISC1. The default is 192.168.205.10.
•
Subnet Mask: The network subnet mask for the ISC1. The default is 255.255.0.0.
•
Default Gateway: The default gateway for the ISC1. The default is 0.0.0.0.
Important:
The ISC1, VAM, and MRM (if one is installed) IP addresses all need to be
on the same subnetwork. The Subnet Mask and Default Gateway settings should be the
same for all components.
5.
Set the VAM IP network information by selecting the Vertical Wave Application Module
from the Network Interfaces drop-down list, and then perform steps 3-4.
6.
If an MRM is installed on your Wave IP 2500, select Media Resource Module from the
list and perform steps 3-4.
Depending on the model, an MRM will have 1, 2, or 3 IP addresses.
Note:
7.
If you have no further chamges to make, go to step 15.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide
Advertisement
Table of Contents
