Vertical WAVE IP 2500 Installation Manual page 95

Appendix B
9CXG +2  5VCVWU .'&U
System Status LED settings are a valuable troubleshooting tool. When you contact your Vertical
technical support representative, you may be asked to describe the System Status LEDs that you
are observing. You can view the System Status LEDs by physically examining the front of the
ISC1 directly, or via the Chassis View applet in the Global Administrator Management Console.
This appendix lists the potential System Status LED settings for the following scenarios:
•
•
•
•
•
0QTOCN HKTOYCTG DQQV UGSWGPEG
You will observe the following status LED setting sequence during a normal firmware boot
sequence after the Wave IP 2500 is powered on.
5VCVWU
Early boot complete. Starting Redboot.
Redboot started.
Redboot loading Linux.
Redboot transferred control to Linux.
Linux decompressing.
Linux booting.
Normal firmware boot sequence
Boot failure indicators
Shutdown sequence
VAM module detection sequence
Factory default IP address setting reset indicators
.'&
off
Red
Red
Red
Green
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
.'& .'&
Green Green
off off
Green Green
Green Green
Blinking red / off
blinking green
.'&
Green
off
off
Green
off
$