Vertical WAVE IP 2500 Installation Manual page 44

Wave IP 2500 Installation Guide
%QPPGEVKPI VJG FKIKVCN UVCVKQP ECTF
The digital station card provides 24 digital station ports. It is full-width card that can be installed
in any universal slot.
See Appendix A, "Trunk and Station Ports and Pinouts" for RJ-21X interface port descriptions
and pinout pairs for the digital station card.
6Q EQPPGEV VJG RQTV FKIKVCN UVCVKQP ECTF
1.
2.
%QPPGEVKPI C OWUKEQPJQNF /1* U[UVGO
A music-on-hold device plays prerecorded music or messages to callers—either from a tape or
CD—when they are placed on hold or while being transferred.
The Wave IP 2500 is compatible with most standard music-on-hold devices that connect via a
3.5 mm stereo plug. If a cable is not provided, you must purchase one separately.
Note:
Caution:
device when installing and connecting the device to avoid possible injury to yourself or damage
to the equipment.
6Q EQPPGEV C OWUKEQPJQNF FGXKEG
1.

Locate the RJ-21X port on the card.
Connect the RJ-21X cable from your punchdown block or multiport adapter to the port.
Although a stereo cable is required, music on hold only plays in mono.
Always follow the instructions supplied by the manufacturer of your music-on-hold
Locate the audio input port (labeled Audio In) on the ISC1.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute