Vertical WAVE IP 2500 Installation Manual page 43

%QPPGEVKPI VJG 6 OQFWNG YKVJ FTQRCPFKPUGTV 8 UGTKCN KPVGTHCEG
The T1 module with drop-and-insert (DNI) V.35 serial interface supports one T1 or ISDN PRI
digital trunk with an integrated CSU/DSU to provide shared data and voice services over a
single T1 circuit. There are 2 connectors on the T1 module:
• The RJ-48C port is used to connect to the T1 or ISDN PRI network interface.
• The DB-60 port provides V.35 serial communications for data connections, for example
to connect to the DB-60 cable from an external router.
The T1 module is a partial-width module that can be installed in any module slot or in any
universal slot via a module carrier.
6Q EQPPGEV VJG 6 OQFWNG
1. Locate the RJ-48C port and DB-60 connector on the module.
2. Connect the T1 cable to the RJ-48C port.
3. Connect the serial cable from your external router to the DB-60 port.
The serial cable may be either a DB-60 male to DB-60 male cable, or a DB-60 male to
V.35 female DCE cable. In either case the DB-60 male connector goes to the DB-60
female port on the ISC1.
Caution:
connector's small size and high pin count, pins on the cable connector can be easily bent
and the DB-60 port may be damaged.
%QPPGEVKPI VJG CPCNQI UVCVKQP ECTF
The analog station card provides 24 analog FXS station ports. It is a full-width card that can be
installed in any universal slot.
See Appendix A, "Trunk and Station Ports and Pinouts" for RJ-21X interface port descriptions
and pinout pairs for the analog station card.
6Q EQPPGEV VJG CPCNQI UVCVKQP ECTF
1. Locate the RJ-21X port on the card.
2. Connect the RJ-21X cable from your punchdown block or multiport adapter to the port
on the Wave IP 2500 using a male RJ-21X connector.
Use care when connecting or disconnecting the serial cable. Because of the
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide