Vertical WAVE IP 2500 Installation Manual page 83

11. When Workstation Setup finishes copying files, if you are installing the TAPI Service
12. Enter the name of the Wave IP 2500 and the Station ID of the phone that will be used by
13. In the next screen, select the User Name of the person assigned to this station ID from the
14. If you are installing the TAPI Service Provider for the first time, Workstation Setup
15. In the Install Completed screen, select the Show What's New checkbox to see a complete
%QPHKIWTKPI VJG 9CXG YQTMUVCVKQP CRRNKECVKQPU
%QPHKIWTKPI 8KGY2QKPV
For information about customizing and using ViewPoint, see the Wave ViewPoint User Guide.
Provider, the TAPI Service Provider Configuration Wizard opens.
the person at this PC.
The station ID corresponds to the port number on the station board to which the phone is
connected. To hear the station ID, pick up the phone and dial *00. If there is not a Wave
phone near this PC, enter a station ID of 0. Click Next to continue.
drop-down list, and enter the user's Password.
If the person at this PC will be using GoldMine contact management software, deselect
the Application can hang up calls checkbox.
Click Finish to continue.
prompts you to define a Windows telephony dialing location for your PC, which is
required to place outbound calls. If you see this prompt, click OK.
• In the Location Information dialog box, select your country from the drop-down
list, enter your area code, and enter the number you must dial to get an outside line,
for example "9". Click OK.
• In the Phone and Modem Options dialog box, select the location from which you
are dialing, and click OK.
listing of the new features available in this version of Wave. Click Finish to complete the
installation.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide