Vertical WAVE IP 2500 Installation Manual page 35

6Q EQPPGEV VJG 9CXG +2  VQ RQYGT CPF RQYGT QP
1.
2.
3.
4.
5.
6.
%QPPGEVKPI VQ VTWPM CPF UVCVKQP RQTVU QP VJG +5%
The RJ-12X port on the ISC1 provides the following:
•
•
See Appendix A, "Trunk and Station Ports and Pinouts" for RJ-21X interface port descriptions
and pinout pairs for the ISC1.
6Q EQPPGEV VQ CPCNQI VTWPM CPF UVCVKQP RQTVU QP VJG +5%
1.
2.
Locate the power outlet and power toggle switch on the back of the Wave IP 2500.
Set the base unit power supply rocker switch and any EXU power switch rocker switches
located on the back of the Wave IP 2500 to the off position.
Connect the power cables from the main chassis and any EXUs to dedicated circuits.
Set each EXU's rocker switch to the On position. (The EXU will not actually power on
until the main chassis is powered on.)
Power on the base unit by toggling the rocker switch.
Observe the status LEDs on the front of the Wave IP 2500 to ensure that the system
initialization completes successfully and that there are no component failures
For complete details of the information provided by the status LEDs, see Appendix B,
"Wave IP 2500 Status LEDs."
4 analog FXO trunk ports that support loop start trunks only.
4 analog FXS station ports.
Locate the RJ-21X port (labeled J1) on the ISC1.
Connect the analog station/trunk cable to the RJ-21X port.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide