Vertical WAVE IP 2500 Installation Manual page 48

Wave IP 2500 Installation Guide
1DVCKPKPI CNN TGSWKTGF *QV(KZGU
Before you begin initial configuration of your Wave IP 2500, contact your Vertical
representative to obtain any required HotFixes and other critical information. Once you have
obtained the HotFix CAB files from your Vertical representative, place them on the hard drive
of the PC that you will use to administer the Wave IP 2500.
Important:
the steps in the next section, where you will change the IP address of the administrator PC. Once
you change the IP address of the administrator PC, that PC will be dedicated to the Wave IP
2500 and you will no longer be able to access your network or go out on the Internet from it.
%QPHKIWTKPI VJG CFOKPKUVTCVQT 2%
Before you can connect to the Wave IP 2500 for initial configuration, you must configure
TCP/IP on the administrator PC that you will use to connect with.
#FOKPKUVTCVQT 2% TGSWKTGOGPVU
The administrator PC must meet the following minimum requirements:
•
•
•
•
Note:
necessary for connecting to the Wave IP 2500.
%QPHKIWTKPI 6%2+2 QP VJG CFOKPKUVTCVQT 2%
1.
2.

Be sure to move the HotFix CAB files to the administrator PC before performing
A Pentium 233 MHz PC running Microsoft Windows 2000 or Windows XP
64 MB RAM
LAN or WAN connectivity through an Ethernet card or modem
Microsoft Internet Explorer 6.0 SP1. Be sure that Internet Explorer is configured to
connect directly to the Internet—do not connect using a defined proxy server.
You may require your Microsoft operating system disks in order to install components
Click Start > Control Panel > Network Connections.
Right-click Local Area Connection and then click Properties. The Local Area Connection
Properties dialog box opens.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute