Wave IP 2500 Installation Guide
6Q EQPPGEV VJG 9CXG +2 VQ [QWT .#0
1.
2.
3.
%QPPGEVKPI VJG 9CXG +2 VQ RQYGT CPF RQYGTKPI QP
Connect the Wave IP 2500 to a dedicated circuit using the supplied power cord. Do not use any
other power cord.
•
As a backup in case ENET 1 is not functional. You can use ENET 2 to connect the
Wave IP 2500 to your network to provide Wave system functionality, as long as
ENET 1 is not used for the same purpose.
•
For troubleshooting or diagnostic purposes, for example internal packet sniffing.
All packets exchanged between the Vertical Application Module (VAM) and the
embedded processor are copied to ENET 2 for diagnostic purposes. (Note that
packet copying does not significantly add to network traffic.)
Locate the 8-pin modular RJ-45 Ethernet port labeled ENET 1 on the ISC1.
Connect one end of a standard, straight-through Ethernet cable to the ENET 1 port.
Connect the other end of the cable to your LAN.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute