Vertical WAVE IP 2500 Installation Manual page 50

Wave IP 2500 Installation Guide
%QPPGEVKPI VQ VJG 8GTVKECN 9CXG +2 
After configuring the TCP/IP protocol on the administrator PC, you are ready to connect to the
Wave IP 2500 for initial configuration.
You can connect to the Wave IP 2500 in any of the following ways:
•
•
%QPPGEVKPI VQ VJG 9CXG +2  XKC [QWT PGVYQTM
This section describes how to connect to the Wave IP 2500 from the administrator PC using a
standard Ethernet cable. You can also connect to the Wave IP 2500 using a network hub, switch,
or router.
1.
2.
3.

Network connection. See the next section.
Local or remote modem connection. See page 4-7.
Connect one end of a standard, straight-through Ethernet cable to the network card in the
administrator PC. Connect the other end of the cable to the RJ-45 Ethernet port labeled
ENET 1 on the front of the ISC1.
Important:
ENET 1 is the Wave IP 2500's primary interface and under normal
conditions it is the only interface that should be connected to your LAN. The port labeled
ENET 2 is only used in special circumstances, as described in "About the Ethernet ports
on the Wave IP 2500" on page 3-9.
Launch Microsoft Internet Explorer. If the administrator PC is running Windows XP
Service Pack (SP) 2, go to step 3. Else, go to step 4.
Warning:
In Microsoft Windows XP SP 2, Microsoft enhanced the default
browser security in Internet Explorer. These security defaults affect the
functionality of Global Administrator Management Console (for example, by
disabling or hiding some applets). To ensure that you do not encounter any
problems when using the Global Administrator Management Console, perform the
following steps:
• On the administrator PC, in Internet Explorer, click Tools > Internet Options.
• Click the Privacy tab.
• In the Pop-up Blocker section, click Settings.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute