Vertical WAVE IP 2500 Installation Manual page 109

Appendix F
7RITCFKPI 4GFDQQV
This chapter describes how to upgrade the Redboot boot loader for the Integrated Services Card
(ISC1).
Important:
Wave ISM on a new Wave IP 2500 for the first time. The latest released version of Redboot
was pre-installed at the time your Wave IP 2500 was shipped.
Perform these steps if the following apply to you:
•
•
Important:
that you have successfully installed the upgrade or HotFix. See the upgrade or HotFix Release
Notes for more information.
$GHQTG [QW DGIKP
Verify the following before you begin:
•
•
You do not need to perform the steps in this chapter if you are installing
You upgraded an existing Wave IP 2500, and the Wave Release Notes indicate that a
Redboot upgrade is required.
At a later time, your Vertical representative notifies you that a new Redboot upgrade is
available via a HotFix.
Before upgrading Redboot according to the instructions in this appendix, be sure
You know the IP address of the Vertical Application Module (VAM) on the Wave IP
2500, and the VAM's login account information.
You can connect to the VAM over your LAN or via a point-to-point Ethernet connection
from the Wave administrator PC or other remote PC.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
(