Vertical WAVE IP 2500 Installation Manual page 84

Wave IP 2500 Installation Guide
%QPHKIWTKPI VJG 6#2+ 5GTXKEG 2TQXKFGT
Workstation Setup runs the TAPI Service Provider Configuration wizard automatically when
you install the TAPI Service Provider for the first time on a PC. You can run the Configuration
Wizard later, for example to change your station ID. To do so:
1.
2.
%QPHKIWTKPI [QWT EQPVCEV OCPCIGT HQT WUG YKVJ VJG 6#2+ 5GTXKEG 2TQXKFGT
Before making calls from the contact manager, you must configure it to recognize the TAPI
Service Provider. Use one or more of the following procedures as needed.
6Q EQPHKIWTG 1WVNQQM
1.
2.
3.
4.
5.
6Q EQPHKIWTG )QNF/KPG )QNF/KPG (TQPV1HHKEG QT )QNF/KPG $WUKPGUU %QPVCEV
/CPCIGT
Use the following procedure after you refer to the documentation that came with the product:
1.
2.
3.
4.
6Q EQPHKIWTG #EV
1.
2.
3.

Click Start > Programs > Vertical Wave > Wave TAPI Service Provider Configuration
Wizard.
Follow the on-screen instructions. Click Help for more information.
Open the Contacts view in Outlook.
Choose Actions > Call Contact > New Call.
In the New Call dialog box, click Dialing Options.
In the Dialing Options dialog box, verify that Connect Using Line is set to "Wave Line
1." This option is available after the TAPI Service Provider is installed.
Click OK.
Choose Edit > Preferences.
Click the Modem tab.
Under Modem Settings, verify that TAPI Line is set to "Wave Line 1." This option is
available after the TAPI Service Provider is installed.
Click OK.
In Act!, Choose Edit > Preferences.
Click the Dialer tab.
Select the Use Dialer checkbox.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute