Vertical WAVE IP 2500 Installation Manual page 62

Wave IP 2500 Installation Guide
6Q TGUVCTV VJG 9CXG +2  CHVGT RQYGTKPI QHH
1.
2.
5VCVWU
Normal firmware operation.
4GUGVVKPI VJG 9CXG +2  +2 CFFTGUUGU VQ VJG HCEVQT[ FGHCWNVU
If you lose or forget the current ISC1 or VAM IP address settings, you can reset them to the
factory default settings.
1.
2.
3.
5VCVWU
Red button press detected at power on.
Programming factory default IP
settings.
Redboot started. Factory default IP
address settings have been applied.

Turn the power switch on the back of the Wave IP 2500 off, wait 30 seconds, and then
turn the power switch on.
When you observe the following pattern on the ISC1 system status LEDs, the Wave IP
2500 is fully operational:
.'&
Green
For a detailed description of the system status LED sequence during normal system
Note:
startup, see "Normal firmware boot sequence" on page B-1.
Shut down the Wave IP 2500, and turn off the power supply switch on the back of the
chassis.
Press and hold the red button on the front of the ISC1.
While continuing to press the red button, turn the power supply switch back on. Wait for
a few seconds until you observe the following status indicator LED sequence, and then
release the red button.
.'&
Red
Red
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
.'& .'&
Blinking red / Blinking green
solid green
.'& .'&
off off
off off
.'&
Blinking green
.'&
Red
Green