Vertical WAVE IP 2500 Installation Manual page 45

2.
3.
%QPPGEVKPI C RCIKPI U[UVGO
A paging system allows Wave users to make public announcements over a loudspeaker.
The Wave IP 2500 is compatible with most standard paging systems that connect via a 3.5 mm
stereo plug. If a cable is not provided, you must purchase one separately.
Note:
Caution:
when installing and connecting the system to avoid possible injury to yourself or damage to the
equipment.
1.
2.
3.
Connect the cable from your music-on-hold device to the port.
Enable music on hold in the General Settings applet of the Global Administrator
Management Console. See the Wave Global Administrator Guide for more information.
Although a stereo cable is required, only one channel is used for paging.
Always follow the instructions supplied by the manufacturer of your paging system
Locate the audio output port (labeled PA Out) on the front of the ISC1.
Connect the cable from your paging system to the port.
Enable paging in the General Settings applet of the Global Administrator Management
Console. See the Wave Global Administrator Guide for more information.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide