Vertical WAVE IP 2500 Installation Manual page 61

6Q EJCPIG VJG PCOG QH VJG 9CXG +2 
14. On any tab, type the new name in the Host Name text box.
15. Click Apply and then click Done to save all of your changes. Note the following:
2QYGTE[ENKPI VJG 9CXG +2 
This section describes various shutdown and restart procedures.
6Q TGUVCTV VJG 9CXG +2  YKVJQWV RQYGTKPI QHH
1.
2.
3.
4.
6Q UJWV FQYP CPF RQYGT QHH VJG 9CXG +2 
1.
2.
5VCVWU
Shutdown button press detected. System
shutdown initiated.
• If you changed IP network settings or configured the Wave IP 2500 for one-click
license activation, your changes take effect immediately. You do not need to restart
the Wave IP 2500.
• If you changed the Wave IP 2500's Host Name, your change will not take effect
until the next time that the Wave IP 2500 is restarted.
In the Global Administrator Management Console, choose Restart System in the General
Administration section.
In the Restart system dialog box, specify how many seconds should elapse before the
system restarts.
Click Restart.
Click Yes at the confirmation screen, and then click OK to restart the Wave IP 2500.
Press and hold the red button on the ISC1.
When you observe the following pattern on the ISC1 system status LEDs, release the red
button:
.'&
Green
System shutdown begins, and when complete, the Wave IP 2500 powers itself off.
For Review Only - Draft Document 09/07/07
COMPANY CONFIDENTIAL - DO NOT Distribute
Wave IP 2500 Installation Guide
.'& .'&
Blinking red / Blinking green
solid green / blinking red
.'&
Blinking green